Showing posts with label LED. Show all posts
Showing posts with label LED. Show all posts

Friday, July 27, 2012

12V BATTERY LEVEL INDICATOR CIRCUIT

This battery level indicator offers (5)
LEDs that light up progressively as the
voltage increases:
  • Red: Power Connected (0%)
  • Yellow: Greater than 10.5V (25%)
  • Green 1: Greater than 11.5V (50%)
  • Green 2: Greater than 12.5V (75%)
Green 3: Greater than 13.5V (100%)
Of course, you may select your own
colors if desired.
12 Volts Battery Level Indicator
Circuit Schematic


Operation of the battery level
indicator

D1 is the voltage reference zener. Tied
to this is a string of divider resistors
(R2-6) that set the various fixed
voltage levels. R7 & 8 form a voltage
divider to that reduces the battery
voltage by a factor of 3. U1 is an
LM339 quad comparator that
compares the various voltages from
the two dividers. The comparator
sections have open collector outputs
that simply function as switches to
operate the LEDs. D7 protects against
reverse battery connection.
The LEDs are biased to operate at
about 4mA which is quite bright if
modern LEDs are used. This current
can be adjusted simply by varying the
series resistors (R9 through R13). The
overall current drain as shown is
about 25mA which tends to be
wasteful for continuous operation. For
energy conservation, connect to
battery via a pushbutton (Push to
Test).
Printed Circuit Board
I did a www.expresspcb.com SMT
layout using 0805 size components,
1N753 zener and SOIC-14 IC. D7 is in
a SOT-23 package. These components
are about as small as I like to work
with. The layout has not yet been
carefully checked or built. Note that
surprises abound when constructing
prototypes.
The circuit board measures only 0.5” x
1.5”.
download the PCB layout
More recently, I located an
inexpensive SOT-23 zener with a 2%
voltage tolerance—this has not yet
been incorporated.
I have had good results with 0805 size
LEDs purchased from China on eBay.
They are both inexpensive and
BRIGHT!

The 12v battery level indicator unit in
the photo has no reverse polarity
diode and R2 is the calibration
potentiometer.
Source: Elektro symetrics

Monday, July 23, 2012

HIGH TEMPERATURE INDICATOR CIRCUIT

In some areas there is a need of
temperature detectors which help
them to detect temperature and
indicate them whether the
temperature is low or not.
Below shown circuit is the simple high
temperature indicator circuit. It will
not show the current temperature
but if it exceeds some threshold
temperature it will detect and indicate.
You can use this circuit anywhere you
needed.

The components needed for the
circuit are:
3 Resistors
1 Temperature dependent resistor
5v battery
Two 1n4007 diodes
One Op-Amp
One LED
And the circuit working is actually very
simple, the Op-amp is connected as
Non-inverting comparator. And a
bridge circuit is made with the
resistors and a Temperature
Dependent Resistor. From above
circuit R1, R2 and R3 are normal
resistors but RT is Temperature
Dependent Resistor.
The bridge resistance and RT are
selected in such a way that as long as
temperature is less than threshold
value, the bridge is unbalanced by
making Voltage at B more than
voltage at A . Hence Vo = -Vsat and
LED is reverse biased and remains
OFF. When temperature becomes
more than threshold then Voltage at B
becomes less that Voltage at A hence
it drives Vo = +Vsat. Due to this, LED
glows and gives high temperature
indication.